A pack of two vinyl tube pieces – for coupling 5mm threaded rod to 5mm stepper motor shafts.
87 Item Items
Warning: Last items in stock!
If you are looking for an affordable way to couple stepper motors to 5mm threaded rod, these vinyl tubes are a perfect solution. Used extensively in the first open source Prusa RepRap 3D printers to keep costs down, they were proved to be an extremely effective way of transferring rotational motion, while allowing for slight threaded rod tolerance issues.
To use these couplers, slide one side onto your 5mm stepper motor shaft, and thread the other over the 5mm threaded rod. Make sure to leave a few millimeters between the shaft and rod, they should not butt up against each other. Finally, secure by tightening a cable tie over the vinyl tube on each.
No customer reviews for the moment.
The eSUN PLA Filament Sample Pack is ideal for...
The Arduino Mega 2560 is a powerful board with...
One of the most common stepper motors used in...
M3x16 Zinc Plated Steel slotted cheese head...
M3x10 Zinc Plated Steel slotted cheese head...