This 12V 40W Heater Cartridge is a standard heating unit that installs directly into the heater block on a hotend assembly. It is compatible with 12V systems, and runs at a higher current than the 24V 40W Heater Cartridge variation.
Installation is relatively simple, as this unit plugs into the motherboard and installs directly into the side of the Heater Block. This enables beginners and veterans alike to upgrade or replace their heater cartridges with ease, and to get back to printing within minutes.
The unit is very efficient and is made from ceramics, which naturally offers faster heating as well as less energy loss than enamel counterparts. It is 20mm long and 6mm in diameter, with a silicone insulated high temperature lead length of 1000mm, which is long enough to cater to most compatible 3D Printers, but can be cut shorter if necessary to make the cable setup neater.
Although this 12V 40W Heater Cartridge is primarily designed to be used with E3D variations of the hotends, specifically the E3D V6 and V5 Direct drive systems as well as Bowden style assemblies, Titan Aero, Chimera, Cyclops and Kraken, but is also compatible with a wide range of other hotend assemblies running 12V systems. It is made to boost the temperatures of the heater block and nozzle, which then heats the 3D Printer Filament to a melting point to extrude it.
Just be sure not to confuse this unit up with the 24V variation, as this could cause problems if your system runs at 12V.
No customer reviews for the moment.
Compression Spring - 23mm Long with 9mm outer...
This 24V 250W Power Supply is a universal PSU...
1kg Spool of CCTree Carbon Fibre Reinforced...
The 48W ZD99 Solder Station is the perfect tool...
1kg of purple PLA eSUN filament spooled and...
0.8mm E3D VMA nozzle for the E3D V6 Volcano hot...
A three degree of freedom magnetometer sensor...
The A4988 Stepper Motor Driver Module is a...