0.4mm MK10 Nozzle for 1.75mm Expand

0.4mm MK10 Nozzle for 1.75mm Filament

1 Review(s)



The 0.4mm MK10 Nozzle is designed for the Wanhao i3, Duplicator 6 and Duplicator 9, made for 1.75mm ABS and PLA filament extrusion.

More details

This product is no longer in stock

R 39.95

tax incl.

Spend R 1,250.00 more and get Free Shipping!

Free shipping on orders over R1250 - courier delivery and within South Africa

This 0.4mm MK10 Nozzle is designed for 1.75mm Filament 3D Printers and is stocked as a replacement part for the Wanhao i3, Duplicator 6 and Duplicator 9. It is made from durable and thermally conductive brass, and is a great choice for 3D printing in ABS or PLA Filaments at relatively high resolutions.

Whether you are looking for a replacement nozzle for your 3D printer, or are eager to upgrade to a larger or smaller nozzle depending on your 3D Printing needs, this 0.4mm nozzle strikes the perfect balance between printing speed and a high level of accuracy.

As a final note, don’t forget to utilise the hot-tightening technique explained below, to ensure that it works optimally in your 3D printer without causing any unnecessary problems.


0.4mm MK10 Nozzle for 1.75mm  -  Technical Specifications:

  • Material

– Brass

  • Input Diameter

– 1.75mm

  • Output Diameter

– 0.4mm

  • Thread Diameter

– M7

  • Height

– 13mm

  • Width

– 9mm

  • 3D Printer Compatibility

– Wanhao i3 / D6 / D9


Simple Guide to Changing your 0.4mm MK10 Nozzle:

When swapping out 3D Printer Nozzles from other components, we recommend utilising the hot tightening technique for optimal thermal coupling. To do this, simply follow these easy steps, while being careful not to burn yourself of course.

  • Unscrew the heat break from the heatsink by about half a turn, to be sure you are not tightening against the heat break in later stages.
  • Heat up your hotend to 285°C, but do not overshoot as you risk damaging your thermistor.
  • Remove the existing nozzle from the heater block and insert the new nozzle.
  • While firmly gripping the heater block, slowly tighten the nozzle. Be careful, however, that you not apply any torque through the heat break, as they are fragile and relatively easy to break when loose.
  • Turn off the heating unit and allow the hot side to cool.
  • Finally, once the nozzle is installed and cooled down, tighten the heat break back into the heatsink and ensure that there are no loose parts.

The reason for this is that the aluminium heater blocks used have a higher coefficient of thermal expansion than the brass and steel used in the nozzles and Heat Breaks. This results in a small gap being created between the nozzle and the break inside the block when the hot end is at temperature, but this only happens if the nozzle has been tightened while cold.



Cois Aucamp

Excellent replacement nozzle for Duplicator i3

Write a review

0.4mm MK10 Nozzle for 1.75mm Filament

0.4mm MK10 Nozzle for 1.75mm Filament