These Silicone Sock Insulators are made to keep E3D V6 Heater Blocks warm and snug, to prevent heat loss and improve part cooling capabilities.
These Silicone Sock Insulators are made to keep CR-10 Series Heater Blocks warm and snug, to prevent heat loss & improve part cooling capabilities.
The Copperhead Hot Block is one of the key parts of the DIY Copperhead Hotend, offering temperature capabilities up to 450°C for rapid 3D Printing.
This Boron Nitride Thermal Paste is ready to handle extreme temperatures, & allows for extreme thermal transfer for Heater Cartridges in 3D Printing.
This amazing Plastic Repellent Paint by Slice Engineering ensures no sticky messes or artefacts on Prints, & keeps your nozzle and heater block clean.
The Mosquito Hot Block Hardware is a set of spares to connect the Mosquito Hot Block & Mosquito Heat Sink on the original & Magnum Mosquito Hotends.
The Mosquito Hot Block is the high-temperature heater block for The Mosquito Hotend, the ultra-light hotend made for high speeds AND high quality.
This E3D V6 Heater Block is made to fit the widely popular E3D V6 Hotend Assemblies, with perfect spacing to fit the PT100 Heater Cartridge.
The MK10 Dual Extruder Heater Block Pack is a great upgrade pack that gives Wanhao’s Duplicator 4 series of 3D printers dual-extrusion capabilities.
E3D Volcano heater block for an E3D Volcano hot end for 1.75mm or 3mm versions.
MK7 heater block for a MK7 Maker Bot extruder.
E3D heater block for an E3D V6 hot end for 1.75mm or 3mm versions.
E3D heater block for an E3D V5 hot end for 1.75mm or 3mm versions.