The Particle FeatherWing Tripler is based on the Adafruit FeatherWing design, to add near-endless expandability to your Particle Mesh Network.
This MOSFET Power Module is a Heatbed Expansion for isolating the main controller board and allowing for multiple different power ratings within the system.
This basic but incredibly helpful IO Expansion Board turns just two pins into 16 I/O Pins Via I2C – Stackable up to 8 times for 128 Total GPIO Pins.
Do you want to build a robot using lots of servo motors like a hexapod? Run out of PWM outputs on your micro or using a Raspberry Pi? Maybe you just want to control LEDs with 12-bits of PWM brightness levels? Then this is the module you have been looking for!
Mosfet switch module on breakout board with screw terminals and pin headers. Useful for controlling high power loads (max 24V / 5A) using 3.3V / 5V logic circuits.
Simple signal amplifier, providing up to 100x non-inverted signal gain from an AC input signal. Supports 5V - 12V DC operation. The LM358 amplifier has large DC voltage gain of up to 100 dB which is ideal for transducer amplifiers, dc gain blocks, and all op-amp circuits.
Simple IR break-beam interrupt sensor module board. This module uses a common IR LED and sensor pair in conjunction with a LM393 comparator IC to drive the output. Arduino Compatible. 5V DC operating voltage.
The 38KHz IR Digital Receiver Module is surprisingly complex for its size, with 38KHz modulation, advanced filtering and versatile binary output signals.
The VS1838 IR Receiver Module allows Makers to integrate IR control into projects or devices and machines around the home and office.
Handy breakout board for surface mount parts to through hole