0.35mm Nozzle for 1.75mm All-Metal Hotend Expand

0.35mm E3D Nozzle for 1.75mm Filament

HWPHNE3D1.75X.35

New

0.35mm E3D Nozzle for either the 1.75mm E3D V5 Hotend Assembly or the 1.75mm E3D V6 Hotend Assembly, for printing in moderate to high resolution.

More details

1 Item

Warning: Last items in stock!

R 8.00

tax incl.

Spend R 1,250.00 more and get Free Shipping!

Free shipping on orders over R1250 - courier delivery and within South Africa

This is a 0.35mm E3D replacement nozzle for the E3D V5 and V6 hotend assemblies for 1.75mm filament.

The brass nozzle is a great general purpose, low cost option making it a favourite choice in the 3D Printing community. Brass has a great balance of properties it is thermally conductive, machines precisely and easily even with very small nozzles and doesn't corrode or pit so retains a smooth surface finish for cleanly laying down extruded filament. The top of the nozzle is threaded in order to fit into the E3D V5 Heater Block or the E3D V6 Heater Block.

It is good to keep in mind that brass nozzles are vulnerable to abrasive erosion by more Exotic Filaments like carbon-fibre filled materials, metal powder filled materials and glow in the dark filaments and also may be damaged by nasty head crashes.

 

0.35mm E3D Nozzle for 1.75mm Filament  -  Technical Specifications:

  • Material Composition

– Brass

  • Input Diameter

– 1.75mm

  • Output Diameter

– 0.35mm

  • Thread Diameter

– M6

  • Hotend Compatibility

– E3D V5 / E3D V6

 

Quick Guide to Changing your 0.35mm E3D Nozzle:

When swapping out 3D Printer Nozzles from other components, we recommend utilising the hot tightening technique for optimal thermal coupling. To do this, simply follow these easy steps, while being careful not to burn yourself of course.

  • Unscrew the heatbreak from the heatsink by about half a turn, to be sure you are not tightening against the heatbreak in later stages.
  • Heat up your hotend to 285°C, but do not overshoot as you risk damaging your thermistor.
  • Remove the existing nozzle from the heater block and insert the new nozzle.
  • While firmly gripping the heater block, slowly tighten the nozzle. Be careful, however, that you not apply any torque through the heatbreak, as they are fragile and relatively easy to break when loose.
  • Turn off the heating unit and allow the hot side to cool.
  • Finally, once the nozzle is installed and cooled down, tighten the heatbreak back into the heatsink and ensure that there are no loose parts.

The reason for this is that the aluminium heater blocks used have a higher coefficient of thermal expansion than the brass and steel used in the nozzles and heat breaks. This results in a small gap being created between the nozzle and the break inside the block when the hot end is at temperature, but this only happens if the nozzle has been tightened while cold.

 

*Note: This is not supplied by E3D, although it is manufactured to the same specs and quality controlled locally to ensure it functions exactly as expected - while saving you money.

 

No customer reviews for the moment.

Write a review

0.35mm E3D Nozzle for 1.75mm Filament

0.35mm E3D Nozzle for 1.75mm Filament