E3D V5 Bowden Cooling Tower for 1.75mm

This is a replacement cooling tower for the E3D V5 Bowden hot end assembly for 1.75mm filament.

The cooling tower is an extremely important part of the cold side of the hot end assembly as it is responsible for keeping the filament cold and preventing blockages before it enters the heat block and nozzle. The cooling tower has an M10 thread at the top for a Bowden connector and machined thread on the bottom end where it is connected to the E3D V5 heat break and on the top end it is connected to the extruder assembly it is also surrounded by a plastic shroud that holds a 30mm fan used to make sure it stays as cold as possible while printing.

*Note: This is not supplied by E3D, although it is manufactured to the same specs and quality controlled locally to ensure it functions exactly as expected - while saving you money.